Bar Straps
Ideal way to secure your motorcycle
£9.99Product Description
Instructions
1. Load motorcycle into van/trailer, placing the front wheel against a secure stop.
2. Place machine on side/centre/paddock stand, or get a second person to hold the machine until secure.
3. Grasp the two cuffs, one in each hand and pull apart far enough to slip the cuffs over each grip. (see diagram) being careful not to foul any switch gear or levers.
4. Pull down on both end loops and attach to your own tie-down hooks, making sure that the anchor points pull down and slightly forward on to the front wheel stop. The tie-down points should always be as far apart as possible t better triangulate the support of your bike.
Warning : The user of the Motrax BarStrap assumes full responsibility for determining the safety and suitability of this device and liability is therefore limited to the replacement of the BarStrap if proved to be defective in workmanship or materials.
Note: Additional tie-downs are required to secure the rear of the motorcycle.
Customer Reviews
Good, but could be better, 23 Jul 2009
Easy to place on the handlebars, but does not come with ratchets to attach it to something, therefore ratchets must be bought separately, bit of a drawback, but when used with a ratchet, a good product.
Anonymous - Leeds
Did the job just fine, 16 Apr 2008
The straps work well as long as you have mounting points in the right place. The keep the bike very stable during transport. I never had any worried about my bike falling over whilst using these, so i would recommend this product.
Martyn Lewins - Nottingham




