Function perfectly.

As the OE indicators on the SV1000s are mounted in fairly deep recesses, i had to use spacers to make them visible from the front of the bike ( two on each side!). Luckily, I had retained the original plastic spacers from the Suzuki indicators, which with new centrally drilled holes (the original holes are offset to the front of the spacers) were just the job.

Smart LED indicators. Had to bodge "seal"

Nice design - clean and modern but not too space-age for my old bike. At 10cm they're just long enough to be seen round my number plate, but still quite compact. Acceptably bright. There's an E-marking though it's hard to spot. Separate resistors included - I didn't need them as I already had a LED flasher. Be sure to fit them the right way round - there's a tiny clip/drain slot in the clear lens, which should face downwards. Wires had 4mm (or so) "bullet" connectors. The terminals looked well made. Unfortunately, my bike uses 2mm ones, so I had to cut them off and do some soldering. The blob of glue holding the wires in the thread will fall out when nuts are first undone. Then not only are they not sealed, there's no strain relief for the wires! I ended up wrapping black tape round the nuts and wires to try to hold the wire and stop mud getting in. I hope this will give them a decent lifespan...

Good product

Had these on my SV650S for nearly two years. They are easy to install and flash brightly. They aren't so small you won't see them, but definitely smaller than most OEM indicators. Only downside is they are quite easy to break. If you catch them with a motorcycle cover or be to rough whilst washing the bike. For the price they aren't bad.